GuizhouRail lift cargo elevatorEveryone see
release time:2023-05-11 16:43:49
GuizhouGuide rail type cargo elevator,

The daily maintenance of the hydraulic lifting platform in normal use is essential, but even if there is normal maintenance on the equipment, any possible problem cannot be ignored, so in order to ensure that the process of using the hydraulic lifting platform for each operation What aspects do we need to check before operation? Today, the editor will give you a popular science.Conscientiously write the special construction plan for installation and construction, and make safety technical disclosures to the installers.GuizhouThings to keep in mind when working at heights When working at a height exceeding . meters, you must use safety nets or safety belts.Secondly, there must be no dirt on the friction surface. If there is dirt, it needs to be washed off with gasoline or thinner; the gear box, gearbox, external gear and other parts of the equipment and the hydraulic oil must be in accordance with the requirements in the table; Correctly maintain the hydraulic guide rail lift. Regularly check whether the wire ropes in each part are broken or loose. If this phenomenon is found, replace them in time. If there is any looseness, it should be tightened in time. The connecting bolts of the equipment should be checked for tightness when the body is under pressure. All connecting shafts should be equipped with cotter pins; check whether each mechanism is operating normally, whether there is noise or failure , to eliminate all faults in a timely manner; when installing dismantling and adjusting the slewing mechanism of the equipment, it is necessary to pay attention to the parallelism between the reducer and the center line of the gear, and the appropriate meshing gap; conduct a comprehensive inspection of the equipment regularly, whether the wires and cables are If there is damage, whether the motor is overheated, replace it in time and continue to run after troubleshooting; ensure that the bearings of the motor, each box,Guizhou3 ton fixed lifting cargo elevator, distribution box and brushes must be kept clean, and the travel switch points of each safety device must be safe and reliable.Nurabad,The design of the hydraulic lifting platform is unreasonable. When the designer designs the cylinder barrel and rod, then there will definitely be problems in the later stage. Therefore, it is necessary to confirm the technical strength of the manufacturer when working on a hydraulic lifting platform; what is the problem with the sound of the oil cylinder of the hydraulic lifting platform? Design drawings to make, the angle of the oil cylinder is slightly deviated, which will cause the sound; the seal quality of the hydraulic lifting platform is different, and the seal with excellent material The continuous friction between the parts and the cylinder wall will cause the sound to be very loud, and long-term wear and tear may scratch the oil cylinder and cause oil leakage, so when the hydraulic lifting platform is used, pay attention to ask the manufacturer what brand and material the seal is used; In some cases of mechanical running-in, it is not ruled out that the above three situations are normal, and there will still be noises. If there is no problem after investigation, then don’t worry. It’s just a running-in problem between mechanical parts. It will disappear naturally.Conscientiously write the special construction plan for installation and construction, and make safety technical disclosures to the installers.Low cost: The cost is much lower than that of the scissor-type mobile lifting platform, so when purchasing a lifting platform, you must consider the scope of use of the lifting platform, the frequency of work, the load and other factors to choose a lifting platform that suits the work requirements .


GuizhouRail lift cargo elevatorEveryone see



What types of lifts are there? There are many types of this equipment, for example, it can be divided into fixed lifting devices and vehicle-mounted lifting devices according to the form of movement. The so-called fixed lifting means that it is generally installed in one place and fixed and then the lifting operation can be carried out. This type of lifting equipment is generally used more on the assembly line. Some large-scale production lines need to move the material when loading materials. Lifting to a certain position, and then putting it into the production line for production, a special lifting device is required to be fixed at a certain position of the production line.What is the pressure of the lifting platform? The movement of the lifting platform has always been our concern now. Our use occasions are uncertain, and most of them are part-time jobs. Therefore, in order to better favor customers, we are constantly researching lifting with good mobility. Platform which can be used in different occasions, but for some large logistics companies or some enterprise processing plants, we are still used to using fixed lifts. It has a huge load capacity and is very stable and strong, which can meet the needs of many customers. This is also In recent years, domestic lifting platforms have been used.Naturally connect the motor to the lift. When connecting, it must be ensured that the concentricity of the output shaft of the elevator is consistent with that of the input shaft of the motor, and that the outer flanges of the two are parallel. If the concentricity is inconsistent, it will cause the motor shaft to break or the elevator gear to wear.Interpretation and observation,Today, confirm whether the motor and the elevator are intact, the input shaft and the groove of the elevator. Fitting tolerances.Brake operators of various mechanisms on the equipment should regularly check and adjust the gap between the brake shoe and the brake wheel to ensure flexibility and reliability. Long-term promotion of freight elevator factory, old brand, price advantage, quality guaranteed!


GuizhouRail lift cargo elevatorEveryone see



The parts such as reduction box, gearbox, external gear and hydraulic oil are all in accordance with the requirements in the table.Price,Always check the connections of the various parts of the hydraulic lift, and tighten them if they are loose. The tightness of the connecting bolts of the body should be checked when the body is under pressure.Mobile lifts are generally used where electric lifts are used in skyscrapers, because there is no need to stop midway, so fast lifts are required. Go from the ground to the high-rise sky lobby (that is, the high-rise elevator lobby, Skylobby), and then transfer to an ordinary elevator to the destination. Some new elevators use the elevator pre-call system, and the designated floor to be reached can be pre-called in the lobby. These passenger lifts can be beautifully decorated according to the needs of customers. Some passenger lifts will be equipped with air conditioners and TVs, and some cars will be equipped with air conditioners, so that customers can enjoy the outside scenery while riding. The long-term elevator factory has no handover to avoid the price difference, and the price is % higher than the market price!The price is higher for more than one ton!Many people think that the strength of the elevator itself is relatively high when using the elevator, so they did not strictly follow the installation method in the manual during the installation process but they do not know that this will cause increased wear and tear of the parts and inflexible operation,GuizhouGuide rail chain lifting cargo elevator, and pay attention to the work The installation precautions corresponding to the environment should not be ignored. Correct installation, use and maintenance of elevators are an important part of ensuring the normal operation of mechanical equipment. Therefore, please be sure to strictly follow the installation and use related matters below, and assemble and use it carefully.Guizhou,The price is guaranteed, the service is guaranteed, and it is a large-scale logistics and storage equipment service company directly operated by the manufacturer. Since the fixed lift is a mechanical device, the quality and performance of the product must be good. Do not accept the products of some manufacturers whose quality is not up to standard, so as to avoid some safety hazards in use.Correct construction elevator site inspection First of all, we need to check the foundation to see if there is any water accumulation, and check whether the grounding system meets the requirements. We also need to check how the structural bolts of the frame are fastened and whether there are any cracks in the welds. We need to follow the instructions to set it up. In mechanical transmission, it can be divided into two types: open type and closed type. Of course, the lift also has a lot of safety equipment.Ensure good power supply at the installation site, install a separate distribution box, and the leakage switch must meet the requirements for construction elevators when used in the distribution box. If the construction elevator installed is frequency conversion, the leakage switch should be adapted to the frequency converter when selecting the leakage switch .


comment list
©2009-2024Industrial Microblog  Sitemap