Sixth, his specifications and dimensions are also related to his total price. Method of forging solid wood floorOrsha, The ground shall be free of water seepage and moisture.The combination of hardness and softness.The wood floor in the living room should be made of boards without knots, cracks and mildew. Generally, Fraxinus mandshurica, camphor and teak are better, because their lines are beautiful and clear, and their texture is moderate.The laying method of wooden floor is not very difficult, but it is required to have a certain carpentry foundation.Firstly, the wood board shall be processed into the length and width coordinated with the room size according to the room size,Orshalow-temperature hot water floor radiant heating, and the floor shall be cleaned before laying.When laying, draw the center point and vertical and horizontal vertical lines of the room, and lay from the center to the four sides. glue and an appropriate amount of cement can be used for bonding between laths.Note that the glue must be coated evenly to avoid the warping of the plate.Music,The combination of hardness and softness.The wood floor in the living room should be made of boards without knots, cracks and mildew. Generally, Fraxinus mandshurica, camphor and teak are better, because their lines are beautiful and clear, and their texture is moderate.The laying method of wooden floor is not very difficult but it is required to have a certain carpentry foundation.Firstly, the wood board shall be processed into the length and width coordinated with the room size according to the room size, and the floor shall be cleaned before laying.When laying draw the center point and vertical and horizontal vertical lines of the room, and lay from the center to the four sides. glue and an appropriate amount of cement can be used for bonding between laths.Note that the glue must be coated evenly to avoid the warping of the plate.In particular, the previous agency said that the laminate floor is a waterproof floor, which is only the surface layer. In fact, the only taboo in the application of laminate floor is small blisters.Related questions edit voice

What does the real wood floor look like? Painting.The density of laminate floor substrate (high density fiberboard) shall be .-. g / cm, and it is not appropriate to have too low or too high density.project,OrshaAntistatic floor manufacturer,Applicable part editing voice Main performance.The general specification and model of general floor is cm×cm, the specification and model of high-capacity floor can reach cm×cm, with a total area of times that of the general wooden floor.The floor is generally made of common materials such as red sandalwood and Huanghua pear wood. The corner material is discarded and made of a key part of the whole tree. It mainly shows the air. The road construction has an endless sense of flexion and extension and three-dimensional feeling.

In order to reduce the cost, which has poor stability and large thermal expansion and cold contraction.The loss is caused by the 'general paving method'.Installation materials,OrshaIs floor glue waterproof,Generally, the plate has a certain degree of expansion, so some gaps (.mm is appropriate) should be left between the laths during splicing to avoid arching.If the floor of the room is uneven, it can be paved with wooden keel for leveling, and then nailed with lath on it. After planing, paint and wax can make the room elegant, extraordinary, clean and warm.A short wooden floor strip has been launched in the market, which can be combined freely according to the size of the room, and can be assembled into a variety of patterns at will.This kind of short plank is more practical, but the disadvantage is that the cost is not low.If the floor is made of wood, the wallboard can also be decorated with plates, it shall be fixed for minutes first×mm vertical wood wall reinforcement, and then fix the plate to the wood wall reinforcement with wood screws.Family decorative wallboard is best based on plywood, and its strength is appropriate.Then stick wood veneer on its surface to make up for the deficiency of plywood pattern.After the veneer is pasted, apply one or two layers of matte paint, and the pattern of the wallboard will be clear and beautiful, both simple and elegant.On the basis of uniform color or reasonable interweaving making the style of the whole room unified, it can make the whole room comfortable and soft, and give people an indescribable sense of mystery.Introduction of floor leatherOf course, its advantage is not just this.Compared with ordinary flooring, what are the reasons for the popularity of SPC flooring?In order to better prevent excessive water from penetrating into the inner layer of wood floor, when selecting floor cleaner, reduce excessive water as much as possible and dry the mop.In addition, when applying wax after cleaning the wood floor, spray wax agent shall be selected to make the wax easy to apply evenly.Wipe off too much oil with a soft cloth to avoid bright spots.Don&#;t rush to choose the wood floor coated with light wax, and dry it naturally at night.