The submersible slurry pump may be blocked when it is used at ordinary times. In particular, some equipment is frequently used at ordinary times, but the maintenance work is not done well when it is used, so it will be blocked after being used for a period of time　　When using the submersible slurry pump, we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motorRoselle,　　The submersible sewage pump operates under water. Compared with other motors,RoselleRubber lining submerged slurry pump, the working environment is poor. Regular inspection and maintenance are essential to ensure the 'health and longevity' of submersible sewage pumps!　　Under the action of auxiliary devices, it can transport the slurry, and because the sealing device itself is special it can also ensure the internal and external balance of the submersible slurry pump during transportation,RoselleVertical centrifugal slurry pump, so that the pressure at both ends of the equipment can be balanced during normal useEkibastuz,　　The vertical sand pump is generally a submersible slurry pump. Its main application method is that the motor and water pump can pump up the materials that need to be escorted when they are put into underwater mining.　　If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m.　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, which can offset part of the axial force and prolong the service life of the bearing.　　 Remove the wire guard, water strainer and cut the cable from the lead and the three core cable or flat cable connector.　　Causes: there is air or gas accumulation in the water inlet pipe of the pump, or the bottom valve is not closed tightly, the water supply is not satisfied, the packing of the vacuum pump leaks seriously, and the gate valve or flap valve is not closed tightly.Quality risk,　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.　　Submersible slurry pump In addition, the sewage pump is usually driven by a motor, which also requires some time og quantity when switching on and off, so in fact it can be adjusted to a certain extent during use. The submersible slurry pump needs to use a line when in use　　Under the action of auxiliary devices, it can transport the slurry, it can also ensure the internal and external balance of the submersible slurry pump during transportation,RoselleSubmersible non clogging sewage pump, so that the pressure at both ends of the equipment can be balanced during normal use

　　 When the power supply voltage is too low, the pump will be overloaded, it may be lower than the rated voltage, so the current in the stator winding will also beWork courses,　　Is called cavitation phenomenon.　　 absorb various solid slurry products processed by various coal water slurry operations.　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.Roselle,　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.　　What is the cause of pump overload.　　The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump, we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latent