The above four methods can be used to detect whether the submersible slurry pump has cavitation, because if the equipment is in use, it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump　　 If the hot water within ℃ is recommended, the hot water pump must be used, and the external tap water shall be connected for cooling during operation otherwise the motor will not be burned due to too high medium temperature.Schoteng,　　 there are two different installation methods, fixed automatic coupling installation system and mobile free installation system.　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.Saki,　　Work,SchotengDrilling fluid slurry pump, no noise and vibration, and the site is cleaner.　　Submersible slurry pump shaft seal type: packing, packing and auxiliary impeller seal, mechanical seal, etc.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, or belt pulley can be used for connection with belt.　　Adjustment. When using the submersible slurry pump and use the PID adjustment of the frequency converter. When

　　It is also necessary to clean the ventilation duct to avoid blockage.　　Installation method: coupling can be used for direct connection, accessories will be used and some auxiliary measures will be taken to improve the overall performance of the equipment and ensure the stable use of the equipment. Many users do not pay attention to these things when using them, which will cause equipment problems and affect work efficiency. So we&#;re usingproduction,　　Reasonable.　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.

　　 There may also be mechanical failure of the pump, such as serious damage to the bearing of the pump, or the impeller will be stuck due to impurities such as water and grass when the pump pumps waterQuality improvement,　　Compared with the vertical slurry pump, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board prospecting, plus it can be installed in any position of the water pipeline, so it is named pipeline pump.　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.Schoteng,　　 There is also a vibration method to measure the vibration frequency of the pump, and the measurement is relatively simple. However, when using one method, the measurement results may have some errors. When using the submersible slurry pump, there are other vibration sources that will affect the measurement results, so it is actually the main　　There will be no insufficient liquid supply or other problems.　　Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. as