Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results and report any problems found to the user unit.Protective measures should comply with regulatory requirements.lush mountain,The up travel (limit) switch should be of the automatic reset type.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Port Mont,When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, the side protection device for the landing entrance should be equipped.plan and a complete grease film surface is maintained between the curved surface of the roller and the main chord of the aluminum alloy electric elevator. A good grease film surface can reduce wear and noiseWhen the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures,Manual pump: When the system malfunctions, with a spacing of mm.The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.

Implementing multiple shifts of homework should fill in and submit records according to regulations.Variable cost,Later,lush mountainElectric elevator 10 meters, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs, it should not be used again to avoid accidents, personnel and property losses.When adding hydraulic oil,lush mountainElectric elevator, we can extend the oil cylinder to the high position for filling. When filling,lush mountainElectric aluminum alloy elevator, the lifting platform should not exceed the high position, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than .m; If the rated speed is not greater than .m/s, the safety distance can be .m.lush mountain,The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movementVertical lead screw electric lifting mechanism: Adopting a lead screw transmission method, it can achieve the lifting of a double-layer tabletop. Multiple lifting platforms can be formed as needed, and different steps can be formed within the travel range to meet the needs of meetings and performances; Pavilion, Terrace, Tower, Pavilion; Ideal props.